|
FAQ
700TS(V), 800TSV -- Resolution 800x600, Picture is not shown completely
Set the refresh rate to 70 or 75Hz. Eeprom Error (Touchscreen Calibration) Deinstall the Touchscreen-Software and drivers and re-install all from scratch. Touchscreen stops working Check in the hardware manager, if the touchscreen runs on the same virtual COM port like eg. a plugged in GPS USB mouse. If yes, change either the COM of the Touch or the other device. Touchscreen is not detected Try VGA resolution 800x600. Do NOT make a check on "PS2AUX" on the touchscreen software installation. (Touchkit) K301 do not extend completely -navigate the LCD in the desired end-position -disconnect the power supply -after 5 sec. reconnect the power supply, the TFT will close automatically -the next time it will opened it should find the correct end-position Overrange Error The following points can fix this error 1.) Set Refresh-Rate to 60 or 70Hz 2.) (only Windows) Boot into Safe-mode and delete all display in the hardware manager 3.) (only VIA ITX) In BIOS under "ADVANCED CHIPSET FEATURES" , set Display Type to "LCD" or "CRT". K301, K500, K90: blister?s on LCD or milky LCD If the protection film is still on your LCD, this could be the reason for the blisters or the milky optic. Please remove the protection film carefully. Use your finger nail and start in a corner of your TFT with removing. K301/K90 is not operating at all The K301/K90 has to be wired like this : Red (AccOn) : Ignition Plus Yellow : 12VDC Black : Ground Park : Ground CID650 / CID700M do not work (functionality test) Red cable = ACC or Light switch cable or Ignition+ thick yellow cable = +12V black cable = GND (ground) If the illumination of the front side is blinking only, the ACC isn’t connected eventually. Connect ACC with +12V and GND to ground to test it. CID650: PC Start/Reset button doesn’t work -> go to VGA mode--Menu key---OSD--SETUP--PC POWER control--pulse or level |
